Acura Legend Wiring

Here is the battery which will be used. (goes along with wiring...sorta...)

This shot is from the engine bay, where you can see there is no factory grommet present.

Here is a shot from the interior of the car, showing behind the driver's side fuse panel the hole where
the 0 awg power wire will enter into the car.

Not the clearest of shots, but this shows the grommet from where the 0 awg power wire
comes from the interior of the car, into the cars wheel well behind the plastic wheel panel.

This last picture shows where the wire is coming out of the wheel well and entering
the engine bay.

Wire is ran along backseat trunk up to the rear deck area.  All wire is zip tied down to plastic
routing cable tie-downs.  Wire is covered in black techflex.

Closer look at tie-downs and techflex.

Shot from the front half of the car.

All cables are covered in tech-flex with heatshrink on the end of the cables.

Just another shot of how the cables are terminated.

Here is the ANL fuse holder mounted under the hood.